diff --git a/docs/products/btn1/setup/getting-started.md b/docs/products/btn1/setup/getting-started.md index c274ff6901..218c5e1073 100755 --- a/docs/products/btn1/setup/getting-started.md +++ b/docs/products/btn1/setup/getting-started.md @@ -10,19 +10,19 @@ This will guide you through adding on switches and keycaps to your BTN-1 then ad ###### Installing Brown Switches -1\. Line up the two gold pins with the holes on your BTN-1, then press down gently. Be careful, as the pins can bend or get damaged if too much force is used. +Line up the two gold pins with the holes on your BTN-1, then press down gently. Be careful, as the pins can bend or get damaged if too much force is used. ![](/assets/btn-1-install-switches-gif.webp) ###### Installing Keycaps -1\. Line up the + on the keycap with the + on the top of the switch you installed. It may require a little pressure, but it should press on smoothly. Once placed, lightly tap to ensure the keycap is fully seated. +Line up the + on the keycap with the + on the top of the switch you installed. It may require a little pressure, but it should press on smoothly. Once placed, lightly tap to ensure the keycap is fully seated. ![](/assets/btn-1-getting-started-installing-keycaps-gif.webp) ###### Flip Power Switch -**1\.** Ensure the power switch is **turned on**. ** ** Because the BTN-1 includes a battery, it must have a physical on/off switch. When the device is on its side, flipping the switch **away from you** turns it **on**, and flipping it **toward you** turns it **off**. +Only the battery version has a power switch. If yours has one, ensure it's **turned on**. With the device on its side, flipping the switch **away from you** turns it **on**, and flipping it **toward you** turns it **off**. ![](/assets/btn-1-flip-power-switch-on.webp) @@ -34,7 +34,9 @@ To connect through the sensor's onboard hotspot follow the below: !!! success "If your sensor is restarting or not broadcasting Wi-Fi try another usb-c cable and power supply!" - ESP devices are sensitive to power fluctuations and require constant 5v power. Our devices use 1amp or less so most used phone chargers will work - just make sure it's a quality one! + The BTN-1 is sensitive to power fluctuations and needs constant 5v power. It draws 1amp or less so most used phone chargers will work, just make sure it's a quality one! + + Still no hotspot? Follow the Reset Wi-Fi Credentials guide to make it broadcast again. 2\. On your phone or PC, open the WiFi settings and connect to "Apollo BTN-1 Hotspot".